One Ferrite Is Not Enough

This would be a great Bond film title…

“So Blofeld, do you expect me to talk?”

“No Mr. Bond, I expect you to solve this radiated emissions problem!”

* laser noises intensify *

 

I was doing some radiated emissions problem solving on a smart LCD module and found an issue that is not new but I haven’t encountered for a while.

In this case, the solution required two ferrites. One on the I/O cable to the module and one on the flexible cable between controller and LCD screen.

Adding only a single ferrite in some cases INCREASED the emissions rather than reducing them, presumably an effect where the addition of the ferrite changes the resonant frequency of either one leg or the entire antenna to the troublesome frequency at 192MHz.

This reinforces the approach of:

  1. Always add new fixes to existing fixes already implemented. Whilst it might be the fifth change that worked, it might not have worked without the previous four.
  2. Once the last fix is in place and validated as working only then can you try and figure out what combination is actually required to solve the problem

The last step can get very busy, particularly if there are a large number of modifications applied. It might only be worthwhile if some are particularly expensive or difficult for the customer to implement in production. Different fixes for different budgets!